NakuLaser Blog

 This is a deuterium lamp & halogen lamp 2IN1 source. The deuterium lamp and the tungsten lamp can be controlled separately. The 2IN1 light source has a pluggable fiber.The fiber is a 400μm anti-ultraviolet fiber. The following is a demonstration video of the operation of this light source. Let's check it now. DH Mini is a compact UV visible light source designed for all types of handheld devices requiring low power consumption UV visible mobile spectrum analysis. DH mini system is a complete UV-Vis-Nir light source, including deuterium lamp, 0.25W tungsten lamp, shutter, light path system and SMA905 interface. All the components are installed on a 12V DC / 600mA power supply. The deuterium lamp, tungsten lamp and shutter can be controlled independently by TTL signal.

 Ytterbium-doped fiber amplifier (YDFA) generates gain by pumping ytterbium-doped fiber with a semiconductor laser to amplify laser signals in the 1030~1100nm band, Hi1060 single-mode fiber or PM980 polarization-maintaining fiber output, the output power is continuously adjustable, with high gain and low The advantages of noise. The desktop YDFA is convenient for experimental operation, and the user can adjust the pump current and output power through the buttons on the front panel. It also provides a more compact modular YDFA, which is convenient for users' system integration. It's a Ytterbium-doped Fiber Amplifier. The front panel has LCD display and control buttons. There is an RS232 interface on the back, which can be connected to a computer and controlled by software. In APC control mode, the output power can be adjusted. In ACC control mode, the operating current can be adjusted. The ACC/APC mode can be switched by the button. The working current and output power can b

 It's a 589nm yellow laser. There are shading parts on the front of the laser flashlight. Before use, you need to open the shading sheet. The threaded metal part of the laser head expands the heat dissipation surface area, which is conducive to the long-term operation of the laser. The blue button is the switch button. There is a switch lock and a safety key at the rear of the laser. The power supply of the laser is an 18650 battery. This is the laser of TEM00 . Let's check it now. Installation introduction. 1. Install the battery first. An 18650 battery, with the positive pole facing the end of the laser. 2. Plug in the remote control switch and key, and the key rotates 90°. 3. Open the front shading part and turn it to the ON position. 4. Press the blue switch button. 5. Warm up for about 5 seconds, the laser starts to work. The real shot effect when the yellow laser spot is on the white baffle.